Using Leap Or Eap-Fast With An Automatically Prompted Login; After Profile Activation Or Card Insertion - Cisco Aironet CB21AG Installation And Configuration Manual

Using LEAP or EAP-FAST with an Automatically Prompted Login

Using LEAP or EAP-FAST with an Automatically Prompted Login

After Profile Activation or Card Insertion

After you (or auto profile selection) activate a profile that uses a separate username and password for
LEAP or EAP-FAST authentication or you eject and reinsert the client adapter while this profile is
active, follow these steps to authenticate.
When the Enter Wireless Network Password window appears (see
Step 1
EAP-FAST username and password and click OK. The domain name can be entered in the Log On To
field; it is optional.
Figure 6-3
The LEAP or EAP-FAST Authentication Status window appears.
If your profile is configured for EAP-FAST and a message appears asking if you want to auto-provision
Step 2
a PAC, click Yes.
If your client adapter authenticates, the LEAP or EAP -FAST Authentication Status window shows that
Step 3
each stage was successful and then disappears. ASTU and the Link Status field on the ADU Current
Status window show Authenticated.
If the authentication attempt fails, an error message appears after the authentication timeout period has
expired. Refer to the
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
6-6
Enter Wireless Network Password Window
"Error Messages" section on page 10-12
Chapter 6 Using EAP Authentication
Figure 6-3), enter your LEAP or
for the necessary action to take.
OL-4211-05