Panic Alarms - Honeywell Lyric User Reference Manual

Panic Alarms

Available Panic modes may vary, depending on the options programmed by your installer.
Please note the difference between the Panic
and the different Panic icons on the touchscreen.
Activating a Panic Alarm
1. Press and hold the
2. Press the appropriate Panic icon on the screen.
Depending on the Panic mode selected, an alarm tone sounds and the appropriate alarm icon
appears on the touchscreen.
Pressing Police typically sends a silent message to your monitoring company*. When you
take your finger away from the Police icon, the screen appears to return to a normal state,
with the button on the Controller blinking. However, the alarm message has been sent.
*
The details of this function's behavior are determined by a setting in the system's programming; we
recommend that you verify the setting with your installer.
Common Panic Icons
Fire Alerts the monitoring company that a fire condition exists. (Displays zone 995)
Alerts the monitoring company that a police emergency exists.
Police
(Displays zone 999, default is silent)
If programmed, alerts the monitoring company to other types of emergency.
Medical
(Displays zone 996)
Activates sirens and sounders on premises without alerting the monitoring company.
Local
(Displays zone 998)
Types of Panic Alarms
Silent emergency
(silent alarm)
Audible emergency
(audible alarm)
Personal emergency
or Aux alarm
Fire alarm
Local alarm
Cancelling a Panic Alarm
NOTE A Fire alarm triggered by the Controller's Panic button cannot be cancelled from
remote services such as Total Connect®. For your safety, Fire and Carbon Monoxide
alarms can only be cleared/silenced from the Controller itself.
Depending on the type of panic alarm in effect, a keypad may appear immediately after the
alarm is initiated.
1. Enter a user code to cancel the alarm.
2. The audible alarms stop and Alarm Cancel appears.
IMPORTANT
button on the Controller until Panic icons appear on the screen.
Sends an alarm signal to the monitoring company, but triggers no audible alarms
or touchscreen display. Requires connection to a monitoring company.
Sends an emergency message to the monitoring company, if connected. A
loud, steady tone sounds at the Controller and external sounders if
connected, and an alarm appears on the touchscreen.
Sends an emergency message to the monitoring company if connected and
sounds at the Controller, but not at external sounders. An alarm icon appears.
Sends a fire alarm message to the monitoring company if connected. A
unique tone sounds at the Controller and external sounders are activated if
connected. A Fire alarm icon appears.
If programmed, activates the sirens and sounders on the premises without
sending a message to the monitoring company.
17
button below the touchscreen