Download Print this page

Honeywell Lyric Quick Install Manual

Hide thumbs

Advertisement

Quick Install Guide

Advertisement

loading

  Summary of Contents for Honeywell Lyric

  • Page 1 Quick Install Guide...
  • Page 2: Getting Started

    You will need the Lyric app to complete setup. Compatibility • The Lyric thermostat works with common 24 volt systems such as forced air, hydronic, heat pump, oil, gas and electric. • Does not work with electric baseboard heat (120/240V).
  • Page 3 Included in your box: You will need: Ballpoint Pen Thermostat Phillips Screwdriver You may also need: Wallplate Wi-Fi Password Small Flathead Screwdriver Mounting Screws Needle-Nose Pliers Wire Stripper Trim Ring...
  • Page 4 Some thermostats may have screws, buttons, or clasps holding the faceplate on. Take a picture of how your wiring looks right now This picture will come in handy when you’re installing your new Lyric thermostat.
  • Page 5 & R-wire configuration A jumper is a connector between two terminals. Do not use any jumpers with Lyric, they’re not needed. Record any jumpers: Jumper Check the box that applies to you. You will need this information in Step 9:...
  • Page 6 Terminal Wire Color V/VR Tip: You can also use the wiring guide in the Lyric app to create a diagram of how to wire your new wallplate. If you have uncommon wiring, visit the Honeywell Wiring support page for instructions on setting up your Lyric thermostat with unique wiring:...
  • Page 7 Disconnect wires & remove the old thermostat’s wallplate Make sure the power is OFF. Tip: To prevent wires from falling back into the wall, wrap the wires around your ballpoint pen. Optional: Attach the trim ring Trim Ring to your wallplate Attach your optional trim ring to the wallplate by snapping the two together.
  • Page 8 Bundle and insert wires Rubber through the wallplate Wire Holder Gather your wires together and guide them through the hole on the back of the wallplate. Do not remove the clear, rubber wire holder. Wall Set R slider tab If you selected Option A in Step 5, keep the slider tab in the R position and insert your R or RC or RH wire into the R terminal.
  • Page 9: Connect Wires

    Tip: You can use a ballpoint pen to release misplaced wires by pushing down on the terminals. Terminals Mount the wallplate Mount the wallplate for your Lyric thermostat using the provided screws. Make sure the wallplate is level by keeping the bubble between the two lines.
  • Page 10 Attach your Lyric thermostat Align your Lyric thermostat onto the wallplate and firmly snap it into place. The thermostat will glow and pulse for up to 3 minutes while it starts up. SCREEN 28: TURN ON POWER SCREEN 28: TURN ON POWER...
  • Page 11 Download the app To configure your new thermostat and finish setup, download the app by searching for Honeywell Lyric in the App Store or Google Play. After downloading, follow the instructions in the app and skip the install step. Caution: Your Lyric thermostat will not control your heating/cooling system until you finish setup in the Lyric app.
  • Page 12 Automation and Control Solutions Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 lyric.honeywell.com 1-800-633-3991 12/18/14...