Appendix: Video Doorbell; Change The Video Doorbell Descriptions And Chime Sound, Or Delete A Video Doorbell; Install A Video Doorbell - Honeywell Lyric User Reference Manual

If your system is set up with a Video Doorbell, you have options to change the doorbell description
and chime tone, or delete it from the system. If you later decide to add a video doorbell to your
system, see the installation and set up instructions below.
Change the Video Doorbell Descriptions and Chime Sound, or
Delete a Video Doorbell
1. Enter the Skybell Setup menu.
Home > Security > Tools > enter Master User Code >
2. A list of enrolled video doorbells appears.
3. Select the Video Doorbell to change from the displayed list.
To Change the Doorbell Descriptor
a. Select the Descriptor button and enter the desired description.
DESCRIPTOR NOTE: Select the desired descriptor from the built-in Lyric™
descriptors. The Video Doorbell cannot use Custom descriptors.
b. Press Save.
To Change the Chime Sound
a. Press the Chime button until you hear the preferred Chime tone for the doorbell.
b. Press Save.
To Delete a Video Doorbell from the Lyric Controller
a. Press Delete next to the doorbell you want to delete.
b. Press Yes at the next prompt and the Video Doorbell is deleted from the Lyric
Controller.

Install a Video Doorbell

Before adding a Video Doorbell to your system, contact your installer and ensure the Video
Doorbell option is enabled in the Total Connect® Service.
System and Internet Requirements
• Full-time internet connection with at least 1.5mbps upload speed.
• The Wi-Fi® router to which the Video Doorbell is connected must operate at 2.4GHz and
support B/G mode. [See your router specifications for modes supported.]
• The Lyric Controller firmware must be revision 01.03.06583.482 or later.
[For firmware revision:
• If the Video Door Bell is not already connected to your Wi-Fi router, download and install the
Total Connect 2.0 mobile app on your smart device.
NOTE: For an alternate method of connection, refer to the instructions that came with the
video doorbell.
Installation process:
• Install the doorbell
• Connect the Video Doorbell to the Wi-Fi Network
• Configure the Video Doorbell for use with the Lyric Controller
• Add the Video Doorbell to the Lyric Controller
(continued on the next page

Appendix: Video Doorbell

Home > Security > Tools > Advanced >System
(go to 2nd page) > SkyBell Setup
65
Information.]