Ko Propo EX-10 Eurus Instruction Manual page 6

Transmitter(backside view)
CHARGING
(Refer P.10)
D.S.C.Terminal
Because the DSC function is installed in this unit, the setting can be confirmed without putting out the electric wave. A D.S.C.
cable (optional) is necessary to use this function.
Receivers that will work with this function should be a KO Propo genuine product which is compatible with DSC.
1.
Turn off the power switch of the transmitter and connect the DSC cable to the DSC terminal.
The power supply of the transmitter enters when the DSC cable is connected.
2.
(Case of KR-409S Usage) Please change mode to "Digital".
(Case of Older Receiver Usage) Please change to NORMAL,HighSPD,or ADVANCE.
3.
The other side of the DSC cable is connected to the receiver.
[Coution!]
The crystal of the receiver is pulled out.
4.
Connect Battery to the receiver.
5.
Connect Servo and check it.
6.
Once you are finished using DSC, turn off the receiver side first then DSC Jack should pulled out.
MultiAccessPort
The multi access port offers a new method of installing, exchanging and the editing of new settings information.Obtaining the
Data Pack and the communications adaptor can be used for the multi access port.
[Data Pack (optional)]
[I.C.S Communication Adaptor(optional)+I.C.S USB Adaptor(optional)]
The two way communication is possible by connecting the PC to your transmitter with the optional interface kit. By
using the software from the interface kit, settings of the transmitter can be edited in PC and the data can be saved
regardless of the number of model memory.
Phone Terminal
The buzzer sound can be clearly confirmed by using the earphone jack. Commercially available Φ3.5earphone for radios can
be used. (MONO type can be used. With STEREO type, only one side will be heard.)
This is useful when you cannot hear the buzzer sound due to other outside noises. The Buzzer sound can be heard from the
transmitter even when the earphone jack is connected.
8
The 10 model memory in the main unit can have an additional 40 model
memory.
RF Module
(Refer P.11)
Phone Terminal
(Refer P.8)
D.S.C.(Direct Servo Control)
Terninal.
(Refer P.8)
MultiAccessPort
(Refer P.8)
[Receivers]
Battery Channel