Procedure When Running - Ko Propo EX-10 Eurus Instruction Manual

Failsafe setting
Failsafe automatically returns throttle (2ch) in desired position
(full brake/neutral) if the model may run out of control.
Switch transmitter on.
Switch receiver on and check servo movement.
Operate throttle trigger in brake/neutral position
(transmitter memorizes the position) Hold set button of
receiver more than 3 seconds.
Release after LED turns off.
Failsafe function can be checked by switching off transmitter. The
data will be memorized until resetting.
When replacing brake linkage of a gas car, resetting is
recommended.

Procedure when running

1.
Power on: Note surroundings and switch transmitter on, then switch receiver on.
2.
Checking model:Confirm model to be used.
3.
Checking movements:Raise wheels from ground and operate transmitter to check movements.
4.
Power off:Switch off in receiver, transmitter order and remove running battery.
Make sure to switch the transmitter on and off after an interval of at least 2 seconds.
14
Detail adjustment using steering/throttle trim lever should be done while running.
Adjust steering balance by operating 8-figure running.
Stand
full brake
Throttle trigger
(full brake/neutral)
neutral
8-figure running
Trim lever
Set button (hold 3
Release Button
seconds)
Turn Off
LED
3 seconds