Ko Propo EX-10 Eurus Instruction Manual page 7

Setting of Wheel and trigger
Adjusting the steering angle
[Procedure]
1.
Remove the sponge from the steering wheel.
2.
Insert the hexagonal socket wrench (2 mm) into the two holes of steering
wheel and tighten the hexagon socket head screws.
3.
Attach the sponge to the steering wheel.
4.
Referring to page 45, set "#ADJVOL" (adjust variable resistor).
To return to the initial state, adjust the hexagon socket head screw so that the tip
does not protrude from the tapped hole by a small distance.
3D Adjustable trigger
The position of the brake lever and the adjustment of the angle can be
freely done.
[Procedure]
1.
A Hexagon socket head screw of the throttle lever is loosened by Hexagon
socket wrench.
2.
The brake lever is adjusted to an arbitrary position.
3.
A Hexagon socket head screw is tightened, and fixed.
Wheel Extention Unit
The installation angle of the steering wheel foil can be freely
adjusted.
Please refer to the manual of the attached paper for the installation of the unit.
[Procedure]
1.
Two Hexagon socket head screws under the wheel extension are
loosened by Hexagon socket wrench (3 mm).
2.
The position is adjusted at the position of the favor.
3.
Hexagon socket head screw is tightened, and fixed.
Color Pad and Replace Grip(optional)
It is possible to exchange it for other color pad and grip.
[How to remove pad or grip.]
Pull in the direction of the arrow (3), the pad removes using your
fingernail (4).
After expanding the lower side (1), the whole grip pulls the in direction
(2) of the arrow.
[How to attach pad or grip.]
Do this in the reverse order of the removal procedure. The lower side of the
pad is slid in. Then using your fingernail the upper side (3) of the pad is
inserted into the transmittor case.
Slide the grip onto the case and then push the six tabs into the case using
your fingernails. If it is not easy to insert the tabs into the case, push them in
by using a minus driver etc. Do not using anything that will damage the case.
Finally, push the guide pins that exists in the lower side (2) into the case.
[Wheel inside]
Hexagon socket
wrench (2 mm)
[Throttle Lever]
Brake lever
[Steering unit]
Pad
Grip
Hexagon
socket
head screw
Steering wheel
Decrement angle
spacer
Hexagon
socket
head screw
(1.5mm)
Ball Joint
Hexagon
socket
head screw
9