Subnet Mask; Default Router; Dhcp - Crestron DMPS3-4K-200-C Supplemental Manual

Subnet Mask

To view or set a subnet mask, do the following:
NOTE:
information, refer to "DHCP" on page 5.
1. On the Network Setup menu, select Subnet Mask. The current subnet mask
2. Using the appropriate soft button under each octet in the subnet mask, select an
3. Press ENTER to apply the subnet mask.

Default Router

To view or set a default router IP address, do the following:
NOTE:
For additional information, refer to "DHCP" below.
1. On the Network Setup menu, select Def. Router. The current default router IP
2. Using the appropriate soft button under each octet in the default router IP address,
3. Press ENTER to apply the default router IP address.

DHCP

DHCP is enabled by default. To enable or disable DHCP, do the following:
1. On the Network Setup menu, select DHCP. The DHCP screen appears on the
2. Do either of the following:
3. Press ENTER to apply the setting. An asterisk precedes the selected setting.
Supplemental Guide – DOC. 7849B
To be able to set a subnet mask, DHCP must be set to Off. For additional
appears on the LCD.
Subnet Mask
000. 000. 000. 000
If DHCP is set to Off, continue with step 2 to set a subnet mask.
octet and then use the VOLUME control or the ▲ and ▼
setting appears in the octet.
To be able to set a default router IP address, DHCP must be set to Off.
address appears on the LCD.
Def. Router
000. 000. 000. 000
If DHCP is set to Off, continue with step 2 to set a default router IP address.
select an octet and then use the VOLUME control or the ▲ and ▼
desired setting appears in the octet.
LCD.
DHCP
*On
• To enable DHCP, select On (default setting).
•
To disable DHCP, select Off.
DMPS3-4K-200-C/300-C Series: 4K Presentation Systems • 5
▼
until the desired
buttons
until the
buttons