Attaching The Front Brackets - Brocade Communications Systems 300 Hardware Installation Manual

FIGURE 31 Rack kit parts
1. Brackets, front (2)
2. Brackets, rear short (2)
3. Screws, 8-32 x 5/16-in., panhead Phillips with patchlock (10)
4. Screws, 6-32 x 1/4-in., panhead Phillips with patchlock (8)
NOTE
The brackets in the kit are labeled UP with an upward pointing arrowhead to reduce confusion in mounting.
NOTE
Depending on the device type , not all parts may be used in an installation.

Attaching the front brackets

CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
Complete the following steps to attach the front brackets to the device.
NOTE
Pay particular attention to the labeling on the brackets.
Brocade 300 Hardware Installation Guide
53-1000862-12
Installing the 1U and 2U Non-Port Side Fixed-Mount Rack Kit (15"-20") for Four-Post Racks (XNA-000072 and XNA-100072)
5. Screws, 10-32 x 5/8-in., panhead Phillips (8)
6. Retainer nuts, 10-32, for square-hole rack posts (8)
7. Clip nuts, 10-32, for round-hole rack posts (8)
49