Brocade Communications Systems 300 Hardware Installation Manual page 40

Slide Rack Mount Kit (XBR-R000070)
5. Repeat these steps for the other rail.
FIGURE 23 Method A for attaching outer slide rails to square-hole rack posts
1. Phillips screw, 10-32 x 1/2 in., black (5 each side)
2. Three-hole slide mount L-bracket (2 each side)
3. Rack post (port side)
4. Outer slide rail
Attaching the rail to square-hole rack posts (Method B)
Perform the following steps to install the square-hole hardware using Method B.
1. Position the outer slide rail inside the rack posts with the closed ends of the slide rail toward the non-port side of the rack, as
shown in the following figure.
40
5. Rack post (non-port side)
6. Three-hole slide mount L-bracket
7. Retainer nut, 10-32 (5 each side)
Brocade 300 Hardware Installation Guide
53-1000862-12