Brocade Communications Systems 300 Hardware Installation Manual page 42

Slide Rack Mount Kit (XBR-R000070)
Inserting the device in the rack
Perform the following steps to install the device in the rack.
1. Position the power cord clips on the outer surface of both outer slide rails, as shown in the following figure.
Ensure that the clips do not interfere with the movement of the rails. Position all the clips either with the tabs above or with the
tabs below the rail.
FIGURE 25 Attaching the power cord clips
1. Three-hole slide mount L-bracket
2. Slide assembly
42
3. Power cord clips (3 each side)
Brocade 300 Hardware Installation Guide
53-1000862-12