Safety Precautions; Time And Items Required; Parts List - Brocade Communications Systems 300 Hardware Installation Manual

Safety precautions

DANGER
Use safe lifting practices when moving the product.
DANGER
Mount the devices you install in a rack as low as possible. Place the heaviest device at the bottom and progressively place
lighter devices above.
CAUTION
Make sure the airflow around the front, and back of the device is not
restricted.
CAUTION
Use the screws specified in the procedure. Using longer screws can damage the
device.
CAUTION
Never leave tools inside the chassis.
CAUTION
Do not use the port cover tabs to lift the module. They are not designed to support the weight of the module, which can fall
and be damaged.
CAUTION
To prevent damage to the chassis and components, never attempt to lift the chassis using the fan or power supply handles.
These handles were not designed to support the weight of the chassis.

Time and items required

Allow 15 to 30 minutes to complete this procedure.
The following tools are required to install a device using the Slide Rack Mount Kit:
• #2 Phillips torque screwdriver
• 11/32-inch wrench
• 1/4-inch slotted-blade torque screwdriver

Parts list

The following parts are provided with the 1U and 2U Slide-Mount Rack Kit for Four-Post Racks (XBR-R000070).
NOTE
Use the screws specified for use with the device. Longer screws can damage the
device.
NOTE
Depending on the device type, not all parts may be used in an installation.
Brocade 300 Hardware Installation Guide
53-1000862-12
Slide Rack Mount Kit (XBR-R000070)
31