Attaching The Device To A Rack; Attaching The Rear Brackets To The Rack - Brocade Communications Systems 300 Hardware Installation Manual

Attaching the device to a rack

Complete the following steps to install the device in the rack.
1. Position the device in the rack as shown in the following figure, providing temporary support under the device until the rail kit is
secured to the rack.
2. Attach the right front bracket to the right rack rail using three 10-32 x 5/8-in. screws and three 10-32 retainer nuts.
3. Attach the left front bracket to the left rack rail using three 10-32 x 5/8-in. screws and three 10-32 retainer nuts.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs)
FIGURE 6 Attaching the device to a rack
1. Bracket, front right
2. Screw, 10-32 x 5/8-in., panhead Phillips

Attaching the rear brackets to the rack

NOTE
Do not use the rear brackets for the Brocade 6505, 6510, or 6520 switches.
Complete the following steps to attach the rear brackets to the rack.
1. Position the right rear bracket in the right rear of the device as shown in the following figure.
2. Attach the brackets using three 10-32 x 5/8-in. screws and 10-32 retainer nuts.
3. Repeat step 1 and step 2 to attach the left rear bracket.
Brocade 300 Hardware Installation Guide
53-1000862-12
Installing the 1U, 1.5U, and 2U Mid-Mount Kit for Two-Post Racks (XBR-000165, XBR-000175, and XBR-R000292)
3. Retainer nut, 10-32
21