Brocade Communications Systems 300 Hardware Installation Manual page 41

2. Loosen and adjust the position of the non-port side L-bracket as necessary.
NOTE
If side rack access is not available, measure the depth of the rack, loosen the L-bracket on the non-port side, and
adjust the bracket position until the total rail length matches the rack depth.
3. Attach the L-brackets to the rack posts using five Phillips 10-32 x 1/2 in. screws, six alignment washers, and two of the three-
hole rack nut bars.
NOTE
Leave the middle hole empty on the port side for securing the rack mount bracket later (refer to
the rack
4. Tighten the screws to 15 in-lbs (17 cm-kgs).
5. Repeat these steps for the other rail.
FIGURE 24 Method B for attaching outer slide rails to square-hole rack posts
1. Phillips screw, 10-32 x 1/2 in., black (5 each side)
2. Three-hole slide mount L-bracket (2 each side)
3. Rack post (port side)
4. Outer slide rail
Brocade 300 Hardware Installation Guide
53-1000862-12
on page 42); however, position an alignment washer between the L-bracket and the rack post.
Slide Rack Mount Kit (XBR-R000070)
5. Three-hole slide mount L-bracket
6. Alignment washer (6 each side)
7. Rack post (non-port side)
8. Three-hole rack nut bar, 8-32 (2 each side)
Inserting the device in
41