IBM Storwize V7000 Quick Installation Manual page 57

| | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Table 9. The following IP address information is required before initializing your system. Fill
in all the information needed in the Value column before proceeding with this
installation. (continued)
Field
Storwize V7000 node canister
2 service IP address
Storwize V7000 subnet mask
Storwize V7000 gateway
address
Internal IP address range
Value
Chapter 3. Configuring the system
Notes
Service IP address of canister
2 in the control enclosure
(such as 123.123.123.21) This
is not set by the USB
initialize or the Easy Setup
Wizard.
Subnet for the above
Storwize V7000 address (such
as 255.255.255.0)
Gateway for Storwize V7000
address to user network
(such as 123.123.123.1)
The internal IP addresses are
for internal communication
among the Storwize V7000
Unified components for
management and
maintenance. Select one of
the IP address ranges listed
below. The range you select
must not conflict with the IP
addresses used for the
customer Ethernet
connections to the
management nodes or
interface nodes. The available
IP address ranges are:
1. 172.31.*.*
2. 192.168.*.*
3. 10.254.*.*
Important:
1. If the customer network
does not use IP addresses
in the 172.31.*.* range
then select range 1.
2. If the customer network
uses IP addresses in the
172.31.*.* range, but does
not use IP addresses in
the 192.168.*.* range, then
select range 2.
3. If the customer network
uses IP addresses in the
172.31.*.* range and the
192.168.*.* range, but does
not use IP addresses in
the 10.254.*.* range, then
select range 3.
47