Step 9. Installing The File Modules; Install The Front End Of The Slide Rails - IBM Storwize V7000 Quick Installation Manual

Figure 21. Install the front end of the slide rails.
5. Press the blue button to release the bracket. Push the front latch in all the way.
Figure 22. Install the front end of the slide rails.

Step 9. Installing the file modules

To install each file module in the rack, follow these instructions:
1. Pull the slide rails forward 1 until they click, two times, into place. Carefully
22
Storwize V7000 Unified: Quick Installation Guide
Make sure the latch is fully engaged. Repeat steps 1 through 5 to install the
other rail into the rack. Make sure that each front latch is fully engaged.
lift the file module and tilt it into position over the slide rails so that the rear
nail heads 2 on the device line up with the slide rails. Slide the file module
down until the rear nail heads slip into the two rear slots, and then slowly
lower the front of the file module 3 until the other nail heads slip into the
other slots on the slide rails.