Initialization Tool Welcome Panel - IBM Storwize V7000 Quick Installation Manual

Figure 46. Initialization tool welcome panel
3. Select the Initialize a new Storwize V7000 Unified (file and block system)
option from the Welcome panel of the initialization tool. Click Next. Use the
initialization tool to complete the following steps:
Note: See 4 for details on IP addresses that are used in these steps.
a. Enter the Storwize V7000 system IP, netmask IP, and gateway IP addresses.
Click Next.
b. Enter the Management IP, Storwize V7000 File Module 1, and Storwize
V7000 File Module 2 IP addresses. Then select 10.254.0.1-10.254.0.4 (or one
of the other address ranges depending on your network configuration) for
the default internal network IP scheme. Click Next.
c. Click Finish on the Final Page and make sure that both the satask.txt and
the cfgtask.txt file are on the USB key. If the files are not on the USB key
refer to USB key and Initialization tool interface located in the Storwize
V7000 Unified Problem Determination Guide PDF on the DVD.
d. Proceed to "Initialize the Storwize V7000" on page 50.
4. If you are running a non-Windows operating system, you must create the files
manually on the USB key. Use table Table 9 on page 46 to determine the
appropriate addresses for the table below.
Chapter 3. Configuring the system
49