Gbps Ethernet Ports On The Rear Of The; Rear View Of A Model 2076-212 Or A Model - IBM Storwize V7000 Quick Installation Manual

|
|
|
|
6
Storwize V7000 Unified: Quick Installation Guide
Note: The reference to the left and right locations applies to canister 1, which is
the upper canister. The port locations are inverted for canister 2, which is the lower
canister.
Figure 5 shows the rear view of a model 2076-312 or a model 2076-324 control
enclosure with the optional 10 Gbps Ethernet ports installed. All other ports
remain the same.
Figure 5. 10 Gbps Ethernet ports on the rear of the Storwize V7000 enclosure
1 10 Gbps Ethernet port 3 which is the left port.
v
2 10 Gbps Ethernet port 4 which is the right port.
v
Expansion enclosure components
Figure 6 shows the rear view of an expansion enclosure and identifies the location
of the power supply units and the canisters. The ports and their use are described
later in this section.
1
Figure 6. Rear view of a model 2076-212 or a model 2076-224 expansion enclosure
v Power supply units are on the left and right of the canisters. Power supply 1
is located on the left. Power supply 2 is located on the right. Power supply 1
is inserted top side up, and power supply 2 is inverted, or top side down.
Important: The power supply units for the control enclosure and expansion
enclosure are not interchangeable.
v Two canisters are housed in the middle of the enclosure. Each canister is known
as an expansion canister. The upper canister, as shown in Figure 6, is canister
3 , and the lower canister is canister 4 . Canister 3 is top side up, and canister
4 is inverted, or top side down.
1 2
2 1
3
4
2