Rear Panel Features - Extron electronics SW HD 4K PLUS Series User Manual

Rear Panel Features

Figure 2.
A
B
C
D
Figure 3.
A
B
C
D
SW2 HD 4K PLUS
INPUTS
POWER
1 2
12V
-- A MAX
A B
SW2 HD 4K PLUS Rear Panel
SW4 HD 4K PLUS
INPUTS
POWER
1 2 3
12V
-- A MAX
A B
Power connector
Input connectors
Output connector
+V connector
SW4 HD 4K PLUS Rear Panel
Power connector — Plug the provided external 12 VDC, 1.5 A power supply into this
2-pole, 3.5 mm captive screw connector and into an AC power outlet.
Input connectors — Connect HDMI video input sources to these female Type A HDMI
connectors.
NOTE: LockIt cable lacing brackets are provided with the SW HD 4K PLUS units.
These brackets secure the HDMI cables to the rear panel connectors and reduce
stress on the connectors, preventing signal loss due to loose cable connections.
Output connector — Connect an HDMI display device to this female HDMI A
connector.
The EDID information is read from the connected output device via this connector and is
written to memory on each input whenever the output device is connected to this port
and powered on.
NOTE: The EDID information is also read and stored whenever power is recycled to
the connected output device or when the output device is replaced.
+V connector — This pin constantly outputs +5 VDC with 200 mA total (shared
between pins). Use this pin when power is needed for external Tally LEDs, such as with
Extron Show Me cables.
G
OUTPUT
1 2
C T C T +V
C
G
OUTPUT CONTACT / TALLY
4
1 2
C T C T +V
C
RS‑232 connector
E
LAN (Ethernet) connector
F
Contact closure input and tally output ports
G
SW HD 4K PLUS Series • Installation
REMOTE LAN
RS‑232
Tx Rx G
D E F
G
REMOTE LAN
3 4 RS‑232
C T C T
Tx Rx G
D E F
5