Installing The Fuselage Servos - Seagull Models BUNKER BU 133 Instruction Manual

INSTALL RUDDER CONTROL HORN.
Repeat steps to install the rudder control
horn as same as steps done for ailerons.
Rudder control horn.
Epoxy.
Rudder control horn.

INSTALLING THE FUSELAGE SERVOS.

Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
1) Install the rubber grommets and brass
collets onto the fuselage servo. Test fit the
servo into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
WWW.SEAGULLMODELS.COM
.
Elevator.
Rudder.
Elevator.
THROTTLE SERVO ARM INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
Loctite secure.
Throttle servo arm.
Throttle.
Adjustable servo
connector.
Servo arm.
5