Setup; Device; Input - Siemens SITRANS LR260 Operating Instructions Manual

2. Setup

Notes:
• See Programming via the handheld programmer
SIMATIC PDM
on page 32 for instructions.
• Default settings in the parameter tables are indicated with an asterisk (*) unless
explicitly stated.
• Values shown in the following tables can be entered via the handheld programmer.

2.1. Device

2.1.1. Firmware Revision (FIRMWARE REV.)
Corresponds to the software or firmware that is embedded in the SITRANS
LR260. Read only.
2.1.2. Loader Revision (LOADER REV.)
Corresponds to the software used to update the SITRANS LR260. Read only.
2.1.3. Hardware Revision (HARDWARE REV.)
Corresponds to the electronics hardware of the SITRANS LR260. Read only.

2.2. Input

2.2.1. Sensor Calibration (SENSOR CALIB.)
You can configure each of the related parameters, to suit your particular
application.
2.2.1.1. Antenna
Sets antenna type.
Values
(view only)
2.2.1.4. Sensor Units
Units the sensor is measuring in.
Values
2.2.1.5. Operation
Options
Page 48 SITRANS LR260 (HART) – INSTRUCTION MANUAL
on page 25 or
No Horn, Horn 2, Horn 3, Horn 4
Default is set by factory depending on horn size.
M, CM, MM, FT, IN
Default: M
SITRANS LR260 stops updating
NO
measurements and associated loop current.
SERVICE
Last valid measurement value is displayed.
Distance to material surface referenced
from Low Calibration Point (process empty
LEVEL
level).
Distance to material surface referenced
SPACE from High Calibration Point (process full
level).
DIS- Distance to material surface referenced
*
TANCE from Sensor Reference Point.
Operating via
7ML19985KE02