Ceiling Fan Assembly - Emerson HIGHPOINT CF205GES01 Owner's Manual

3. Ceiling Fan Assembly

3.13
Place the ceiling cover over the downrod. Then reinstall
the hanger ball (Figure 13) on the downrod as follows.
Route the three 80" motor leads through the hanger ball
and slide the hanger ball over the downrod. Position the
pin through the two holes in the downrod and align the
hanger ball so the pin is captured in the groove in the top
of the hanger ball. Pull the hanger ball up tight against the
pin and securely tighten the setscrew in the hanger ball.
A loose setscrew could create fan wobble.
3.14
The fan comes with black, blue and white leads that are
80" long.
Measure up approximately 6 to 9-inches above top of
hanger ball / downrod assembly (Figure 14).
Cut off excess leads and strip back insulation 1/2-inch from
end of leads.
You have now completed the initial assembly of your new
ceiling fan. You can now proceed with hanging and wiring
your fan.
Please call Emerson
1-800-654-3545 if you
about installation and operation of this ceiling fan.
technical support at
have any questions
(Continued)
PIN
DOWNROD
CEILING
COVER
Figure 13
1/2-INCH
6 TO 9
INCHES
DOWNROD
CEILING
COVER
Figure 14
10
HANGERBALL
SETSCREW
BLUE WIRE
BLACK WIRE
WHITE WIRE
HANGER BALL
U.L. Model No.: CF205