Table of Contents
Advertisement
3. Ceiling Fan Assembly
3.3
Your ceiling fan can be assembled with the light kit
and glass or without the light kit and glass.
To assemble without the light kit and glass, you will
use the no-light cover plate. In order to use the
no-light cover plate, the light sockets will need to be
removed from the light kit plate.
NOTE: In order to remove the light sockets, the wires
on the light kit plate will need to be cut. MAKE SURE
THIS IS THE NO LIGHT ASSEMBLY DESIRED.
NOTE: If no light kit is to be used on the ceiling fan,
disregard Steps 3.3 and 3.4; proceed to "How to
Disassemble Your Light Kit for Cover Plate Assembly
Only", then continue to Step 3.5.
Connect the white wire from the light kit plate to the white
wire in the fan motor/ housing assembly (Figure 3).
Connect the black wire from the light kit plate to the black
wire in the fan motor/housing assembly.
CAUTION: Before installing and tightening the
screws, be sure there are no wires pinched between
the light kit plate and the fan motor/housing
assembly.
3.4
Remove one of the fan motor/housing assembly screw
(retain for later use). Position the light kit plate on the fan
motor/housing assembly aligning the keyhole slots over
the fan motor screws. Rotate the light kit plate clockwise to
engage the screws into the keyhole slots. Reinstall the
previous removed screw. Tighten the three screws to
secure the light kit plate to the fan motor/housing
(Figure 4).
A spare #8-32 x 10 mm pan head screw with lockwasher
supplied in parts bag, if needed.
3.5
Carefully remove the fan assembly from the lower foam
pad. Turn the partially assembled ceiling fan over and
position it on the lower foam pad. The light kit plate should
be resting on the pad so that the top of the motor faces up.
(Continued)
WHITE WIRES
Figure 3
MOTOR SCREW (3)
Figure 4
6
LIGHT KIT
PLATE
BLACK WIRE
BLUE WIRE
FAN MOTOR/
HOUSING
ASSEMBLY
LIGHT KIT PLATE
U.L. Model No.: CF205
Advertisement
Table of Contents
