Table of Contents
Advertisement
9. Remote Control Procedures
9.6
The light (
) push button turns the light on and off and
controls the light intensity (Figure 39).
To vary the intensity of the light, hold the
(
) button down until the desired light intensity is
reached, then release the button (Figure 39).
NOTE: When turning the light on, light will turn on at
the light intensity previously selected.
Your remote control has full control of your fan and light.
The power indicator light (blue glow) will illuminate while
any button is pressed, indicating that the battery is good.
9.7: Storage Bracket Installation
A storage bracket is provided for holding your remote
control when not in use. If you desire to use the bracket,
install it on a wall that is away from excess heat or
humidity.
Slide the wall bracket cover up to expose the screw holes
for installation (Figure 40).
Position the bracket on the wall in desired location.
9.8: Storage Bracket Installation
Install the two screws (provided with bracket) into the wall
bracket and tighten to secure to wall (Figure 41).
Slide the wall bracket cover back down over the screws.
(Continued)
POWER INDICATOR
LIGHT
LIGHT BUTTON
Figure 39
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 40
COVER
WALL
BRACKET
SCREWS (2)
Figure 41
24
HIGH TO LOW
BUTTONS
TO INSTALL BRACKET TO
WALL:
SLIDE THE COVER UP TO
EXPOSE THE SCREW
HOLES FOR INSTALLATION
TO INSTALL BRACKET
TO WALL:
INSTALL THE TWO SCREWS
SLIDE THE COVER DOWN
U.L. Model No.: CF205
Advertisement
Table of Contents
