Table of Contents
Advertisement
3. Ceiling Fan Assembly
3.8
Align the clevis pin holes in the downrod with the holes in
the motor coupler.
Install the clevis pin and secure with the hairpin clip
(Figure 8).
The clevis pin must go through the holes in the motor
coupler. It is critical that the clevis pin in the motor coupler
is properly installed and securely tightened.
Retighten the two Phillips head set screws to secure the
downrod to the motor (Figure 8).
WARNING
!
It is critical that the clevis pin and setscrews in the motor
coupler are properly installed and securely tightened.
Failure to verify that the pin and setscrews are properly
installed could result in the fan falling.
3.9
Make sure the grommet is properly installed in the coupler
cover, then slide the coupler cover on the downrod until it
rests on the motor housing (Figure 9).
3.10
NOTE: If you installed the 6" downrod, the three
decorative rod assemblies and the rod support
assembly will not be installed. Disregard Steps 3.11
through 3.12; proceed to Step 3.13.
Make sure the grommet is properly installed in the rod
support assembly. Slide the rod support assembly onto the
downrod (Figure 10).
Then position the three screws in the rod support
assembly toward the top (Figure 10).
(Continued)
HAIRPIN
CLIP
CLEVIS
PIN
CLEVIS
PIN
RETIGHTEN
PHILLIPS HEAD
SET SCREW (2)
Figure 8
MOTOR
HOUSING
Figure 9
ROD SUPPORT
ASSEMBLY
Figure 10
8
MOTOR
COUPLING
HAIRPIN
CLIP
GROMMET
COUPLER
COVER
GROMMET
SCREWS (3)
(Toward Top)
COUPLER
COVER
U.L. Model No.: CF205
Advertisement
Table of Contents
