Page 1
Oil Rubbed Bronze CF717SW00 Satin White 18.8 Net Weight: Lbs. Questions, problems, missing parts: Before returning to the store call Emerson Electric Customer Service 8 a.m. - 6 p.m., Eastern, Monday-Friday 1-800-654-3545 Part No. F40BP74830000 Form No. BP7483 www.emersonfans.com Revision: 131215...
Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson could Additional Safety Instructions for Installation result in personal injury or property damage.
Emerson Electric Co. Substitution of parts or Hanger Ball/4.5” Downrod Assembly accessories not designated for use with this product Light Kit Assembly by Emerson Electric Co. could result in personal injury Bowl Cap or property damage. Finial Nut 60 Watt Candelabra Bulbs...
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 4 1. Unpacking Instructions (continued) This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Installed Wire Length Wire Size A.W.G. Up to 50 ft.
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 5 IMPORTANT Your ceiling fan is designed to be installed either in the standard manner, or in the close-to-the-ceiling manner. Using the standard method, the hanger ball/downrod assembly will suspend the fan several inches below the ceiling cover. Using the close-to-the-ceiling method, the ceiling cover installs directly on the fan motor housing, thus mounting the fan 3-1/2 inches closer to the ceiling than the standard method.
Page 6
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 6 3. Installing Hanger Ball/Downrod Assemby (For Standard Mounting) (continued) Securely tighten the two setscrews into the motor DOWNROD coupler until they rest against the downrod. MOTOR SETSCREWS (2) Pull up on the downrod to make sure the setscrews are COUPLER firmly installed against the downrod (Figure 3).
Page 7
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 7 3. Installing Hanger Ball/Downrod Assemby (For Standard Mounting) (continued) HANGER BALL Reinstall the hanger ball (Figure 6) on the downrod as follows. Route the 42-inch motor leads through the DOWNROD hanger ball. Position the pin through the two holes in the downrod and align the ball so the pin is captured in SETSCREW the groove in the top of the hanger ball.
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 8 4. Installing Ceiling Cover on Fan Motor Housing (For Close-to-the-Ceiling Mounting) Remove and retain six screws and lockwashers from the top of the motor housing (Figure 8A). Remove the paper backing off the rubber gasket (supplied in parts bag) to expose the adhesive.
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 9 5. Installation of Hanger Bracket WARNING The fan must be hung with at least 7' of clearance from floor to blades (Figure 11). WARNING OUTLET BOX LOOSEN TWO Turning off wall switch is not sufficient. To avoid SCREWS (SUPPLIED possible electrical shock, be sure electricity is turned T-SLOT...
Page 10
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 10 5. Installation of Hanger Bracket (continued) Slide the hanger bracket onto the outlet box screws. Center the bracket over the outlet box and then securely tighten the screws (Figure 13). WARNING Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, use leveling washers SECURELY between the hanger bracket and the outlet box until...
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 11 6. Hanging the Ceiling Fan (Standard Method Using Hanger Ball/Downrod) Carefully lift the fan assembly and seat the hanger ball in the hanger bracket (Figure 14). The tab on the hanger bracket must seat in the groove in the hanger ball.
Emerson Electric Co. Substitution of parts or connectors supplied. accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage. Securely connect the fan motor white wire to the supply WIRE CONNECTOR...
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 13 9. Installation of Ceiling Cover Remove the left screw and lockwasher from each side of the hanger bracket (Figure 18) and loosen the other two screws. NOTE: When installing the ceiling fan using the close-to-the-ceiling method, carefully lift the fan assembly from the hook on the hanger bracket and proceed as follows.
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 14 10. Installation of Ceiling Fan Blades 10.1 Remove and discard the five motor hub spacers to free the motor for installation of ceiling fan blades (Figure 20). MOTOR HUB MOTOR HUB SPACERS (5) Figure 20 10.2 #8-32 x 8mm WASHER...
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 15 11. Installation of Light Kit Assembly 11.1 Engage the connector of the light kit assembly with the motor connector (Figure 23). The two connectors are keyed and color-coded and must be mated correctly (color-to-color) before they can be engaged.
Page 16
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 16 11. Installation of Light Kit Assembly (continued) 11.4 Position the fan speed control switch pull chain through the side hole of the light kit fitter plate (Figure 26). NOTE: Be sure that the fan switch chain does not make contact with the light bulbs.
29). LIGHT CONTROL SWITCH PULL CHAIN SPEED CONTROL SWITCH PULL CHAIN COUPLING COUPLING Please call Emerson technical support 1-800-654-3545 if you have any questions SMALL WOOD LARGE WOOD PENDANT about installation and operation of this ceiling fan. PENDANT Figure 29 12.
Emerson Electric Co. Substitution of parts or accessories not designated for use with this product The use of any other control not specifically approved by Emerson Electric Co. could result in personal injury for this fan could result in fire, shock and personal or property damage.
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 19 15. Trouble Shooting WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1.
Page 22
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 22 Notes ETL Model No.: CF717...
Page 23
What We Will Do To Correct Problems: If during the one (1) year warranty period the motor or any component or accessory of your Emerson Ceiling Fan is defective in materials or workmanship, or if during the expected lifetime of the Emerson Ceiling Fan (when used in accordance with the User Manual or other instructions) the motor is defective in materials or workmanship, you must contact Emerson during the applicable warranty period.
Page 24
12/19/13 9:59 AM Page 24 Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant • St. Louis, MO 63136 Questions, problems, missing parts: Before returning to the store call Emerson Electric Customer Service 8 a.m. - 6 p.m., Eastern, Monday-Friday 1-800-654-3545 www.emersonfans.com...