Bitrate Command - Basler A102K User Manual

4.2.8 Bitrate Command

Purpose:
Type:
Write Command:
Response:
Data Format:
When changing the bitrate for serial communication, use the following procedure:
1. Issue the write command with the new bitrate.
2. Wait one second.
3. Change the bitrate on the serial port that the camera is using:
4. Restart the PC and the camera.
5. Resume communication.
Note: The RS-644 serial port on some Camera Link frame grabbers will only support
a bitrate of 9600. If you are using a Camera Link frame grabber, check the grabber's
documentation before attempting to change the bitrate.
k
BASLER A102
To set the bitrate of the serial communications link. The bitrate is changed immediately after
the successful receipt of this command. (The default bitrate is 9600.)
This is a write only command.
Cmd-ID
0x44
None
Byte 1
Byte 2
Byte 3
Byte 4
ID Bitrate
0x12 4800
0x13 9600
0x14 14400
0x15 19200
0x17 38400
0x19 57600
0x1A 76800
0x1B 115200
a) If you are using a Camera Link frame grabber, change the bitrate on the frame
grabber's RS-644 serial port.
b) If you are using the camera with a k-BIC, change the bitrate on your PC's
RS-232 serial port.
DRAFT
R/W-Flag Data Length
0
An ID that specifies the bitrate (see table below).
undefined - always write 0x00
undefined - always write 0x00
undefined - always write 0x00
Configuring the Camera
Data
4 4 Bytes
4-27