Table of Contents
Advertisement
6-Pin Micro-miniature Receptacle
The pin assignments for the 6 pin, micro-miniature receptacle used to supply power to the camera
are shown in Table 2-2.
Pin
Number
[1]
1, 2
3
4
[2]
5, 6
[1]
Pins 1 and 2 are tied together inside of the camera.
[2]
Pins 5 and 6 are tied together inside of the camera.
Table 2-2: A102
Figure 2-2: A102
2.1.3 Connector Types
The 26 pin connector on the camera will be a female .050" MDR connector as called for in the
Camera Link Specification.
The 6 pin connector on the camera will be a Hirose micro-miniature locking receptacle (part #
HR10-7R-6PA) or the equivalent. The recommended mating connector is the Hirose micro-
miniature locking plug (part # HR10-7P-6S). A Hirose locking plug will be shipped with each
camera. This plug should be used to terminate the cable on the power supply for the camera.
k
BASLER A102
Signal
Direction
Name
12 V In
Input
Input
DC Gnd
Pin Assignments for the 6-pin Micro-miniature Receptacle
k
Pin Numbering
k
DRAFT
Level
Function
+12 VDC
Camera Power Input
Not Connected
Not Connected
Ground
DC Ground
1
6
5
2
3
4
13
1
26
14
Camera Interface
2-3
Advertisement
Table of Contents
