Table of Contents
Advertisement
Keep in mind that the Work Set is stored in a volatile memory. Any changes you make
to the Work Set using the configuration tool will be lost when the camera is switched
off. To save changes you make to the Work Set, save the modified Work Set into one
of the camera's 15 User Sets. The User Sets are stored in non-volatile memory and
will not be lost when the camera is switched off (see Section 3.11).
Alternatively, you can also save the Work Set to the hard disk of your computer and
load it from hard disk.
If you want your changes to be loaded into the Work Set at the next power on, set the
Startup Pointer to the User Set where you saved your changes.
4.1.4 Configuration Tool Help
The CCT+ includes a complete on-line help file which explains how to change a setting or to copy
the Work Set to a User Set, to Copy a User Set or the Factory Set to the Work Set, or to set the
Startup Pointer. To access on-line help, press the F1 key whenever the configuration tool is active.
k
BASLER A102
DRAFT
Configuring the Camera
4-3
Advertisement
Table of Contents
