Rear Panel - CYP CPLUS-V4H1HP Operation Manual

INPUT: Press this button to sequentially switch through the 4
5
available inputs.
6 INPUT LED 1~4: These LEDs will illuminate GREEN to indicate which
of the 4 sources are currently selected.

6.2 Rear Panel

HDMI IN
1 2
1
1 HDMI IN 1~4: Connect to HDMI source equipment such as a media
player, game console or set-top box. DVI source equipment may
be connected by using an HDMI to DVI adapter.
HDMI OUT: Connect to HDMI TVs, monitors or amplifiers for
2
digital video and audio output. DVI display equipment may be
connected by using an HDMI to DVI adapter.
SERVICE: This slot (USB 2.0) is reserved for firmware update use only.
3
CONTROL: Connect directly, or through a network switch, to your
4
PC/laptop to control the unit via Telnet/WebGUI.
RS-232: Connect directly to your PC/laptop to send RS-232
5
commands to control the unit.
6 IR IN: Connect to the provided IR Extender to extend the IR control
range of the unit. Ensure that the remote being used is within direct
line-of-sight of the IR Extender.
DC 5V: Plug the 5V DC power adapter into the unit and connect it
7
to an AC wall outlet for power.
6.3 Remote Control
POWER: Press this button to power on the unit or place
1
it into stand-by mode.
2 INPUT 1~4: Press 1 through 4 to select the input source.
3
HDMI OUT
3 4
2
SERVICE CONTROL RS-232
3 4 5
IR IN DC 5V
6 7
POWER
1
1 2
2
3 4
INPUT
CR-72