Copying From The Bypass Tray - Ricoh C4540 Operating Instructions Manual

Copying

Copying from the Bypass Tray

Use the bypass tray to copy onto OHP transparencies, adhesive labels, translu-
cent paper, postcards and copy paper that cannot be loaded in the paper trays.
Important
❒ When the duplex unit is attached, the default is [1 Sided
2
copying from the bypass tray, cancel [1 Sided
ries]. You can change the initial settings. See "Programming Defaults in Initial
Display".
❒ Paper that has a vertical length of 90-305 mm (3.6-12 inches) and a horizontal
length of 148-457.2 mm (5.9-18 inches) can be copied from the bypass tray.
However, when paper larger than 433 mm (17.1 inches) in size is used, the pa-
per may become wrinkled, may not be fed into the machine, or may cause pa-
per jams.
❒ The machine can detect the following sizes as regular size copy paper: 11"
1
17"L, 8 /
than the above, be sure to specify the size.
❒ When copying on OHP transparencies or paper heavier than 81 g/m
70 kg, 21 lb.), you need to specify the type and size of paper with "Special
Original".
❒ The maximum number of sheets you can load at the same time depends on
paper type. The maximum number of sheets should not exceed the upper lim-
it.
❒ When copying paper lighter than 59 g/m
ify the paper type.
❖ [Bypass Tray Usage]
Press [Bypass Tray Usage] to display a description on using the bypass tray.
34
1 1
" 11"L, 5 / " 8
2 2
2 Sided] in [Dup./Combine/Se-
/ "L. If you want to use the size of paper other
2
2
or tracing paper, you need to spec-
2 Sided]. When
2
(about
Draft 2006/03/07