Static Generator Values 400/620/625 Sc / 660 Smc (Kokusan 4K-3, 3C) - KTM 400-660 LC4 1998-2005 Repair Manual

STATIC GENERATOR VALUES 400/620/625 SC / 660 SMC (KOKUSAN 4K-3, 3C)

Measuring conditions:
– cold engine
– seat, right side trim and tank removed
– all connectors and the ground connection in a non-corroding condition, connectors tightly connected
– light switch turned off
– compression release lever pulled
– kick the kick starter forcefully at least 5 times for each measurement
7
10
S
Check the generator output
page) for voltage between the following cable colors:
– between yellow and brown (ground), connector
– between white and brown (ground), connector
8
– Repeat both measurements with connector
The measured values should be the same.
NOTE: The black measuring lead of the peak voltage adapter must be
applied to the ground.
Check regulator rectifier output voltage
opposite page, cable colors yellow/red), regulator rectifier
connected, capacitor
– between yellow/red and brown (ground)
NOTE:
– The black measuring lead
applied to the ground.
– The regulator rectifier
6
(also see circuit diagram on opposite
Multimeter display: 15 volts +/- 1 volt
Multimeter display: 19 volts +/- 1 volt
9
bl
disconnected:
Multimeter display: 14 volts +/- 1 volt
S
of the peak voltage adapter must be
bk
is located on the right behind the side trim.
7-50E
7 disconnected
8
disconnected
7 8
and connected.
(also see circuit diagram on
bk