KTM 400-660 LC4 1998-2005 Repair Manual page 181

2
4
5
7
8
– Twist the mixture adjusting screw
counting and writing down the number of twists. Twist out the
mixture regulating screw and remove it together with the spring, the
washer and the O-ring.
– Twist the adjusting screw
writing down the number of twists. Twist out the adjusting screw
and remove it together with the spring, the O-ring and the washer.
1
– Remove screw
the fuel filter.
3
– Twist out the jet holder
– Remove the 3 screws
together with the gasket.
6
– D
O NOT DAMAGE THE MEMBRANE WHEN REMOVING THE PUMP HOUSING
R
EMOVE THE MEMBRANE BEFORE CLEANING THE PUMP HOUSING
– A
DJUSTMENT SCREW
– Clean all jets and other components and blow them through with
compressed air.
– Clean the carburetor housing and use compressed air to blow
through all ducts within the carburetor.
– Check all gaskets for damage and exchange them, if necessary.
2
clockwise all the way in, counting and
3
, and take off the hose connection together with
4
together with the accelerating jet
6
and take off the entire pump housing
!
CAUTION
8
IS FACTORY CALIBRATED AND MUST NOT BE TURNED
8-17E
1
clockwise all the way in,
5
.
!
.
.
7
.