Setting Up The Camera - Angelcare AC315 Owner's Manual

WARNING
STRANGULATION HAZARD
• Remove all slack from Sensor Pad Cord.
• When lowering the mattress support
as your child grows, slide the vertical
Cord Cover downward so it remains
approximately in the center between
the mattress support and the floor. Slide
the Sensor Pad Cord through the Floor
Cover to eliminate any additional slack
STEP 3 - SETTING UP THE CAMERA
1
Note: Each time you power ON your Camera, the internal thermometer will need to
calibrate to ensure accuracy. This automatic process will take approximately 30 minutes.
The colour changing temperature display, by default, will be turned "OFF". You may turn
this feature "ON" in the settings mode on your Parent Unit.
CAMERA
Front Side
STEP 4 - TURNING ON YOUR MONITOR
Your Camera and Parent Unit come pre-paired.
ON
OFF
1
01m5_Manuel_AC315_UK_12703.indd 7
• The Sensor Pad is not
designed for use with
adults, children or
infants older than
24 months.
• Discontinue used of the Sensor Pad
when baby is older than 24 months.
Remove Sensor Pad from cot and store
for future use.
• BEFORE FIRST TIME USE: To test
that the unit is ready for use, refer to
instruction manual on how to test that
the installation has been done correctly.
1) Connect the USB plug to the
2
Camera.
2) Connect the USB plug with the
power adapter and then with an
electrical outlet.
3) Adjust the Camera using the
magnetic mount to get the best
view of baby in the cot.
Pause Sensor Pad/
Pairing button
Speaker
Microphone
Camera
Room
temperature
display
Micro USB
charging port
1) Slide the Camera ON/OFF switch to the ON position.
POWER ON/OFF
Magnet for
Rear Side tabletop stand
and wall mount
2017-10-16 9:19 AM
E
N
7