Angelcare AC315 Owner's Manual page 6

2.3 - INSTALL THE SENSOR PAD ON THE MATTRESS SUPPORT
IMPORTANT
If your cot does not have a solid, stable surface for the Sensor
Pad, you will need to place a support under it, to ensure correct
operation of the system.
This hardboard support should be at least 6 mm thick and should
have minimum dimensions of 33 cm x 33 cm. This support board
must be larger than the Sensor Pad surface area.
The Sensor Pad functions with any size and type of mattress except memory-foam
mattresses, hollow frame mattresses and water beds. The hardboard maintains a
constant pressure on the Sensor Pad, enabling it to detect the baby's movements even
when the baby is at the edges of the cot.
2
Sensor Pad
4
6
7
4
8
4
6
01m5_Manuel_AC315_UK_12703.indd 6
5
6
3
5
8 cm
CLICK!
3 2
9
3
2
1
1) Remove the mattress from
the cot.
4
2) Place the Sensor Pad –
3
Angelcare logo side up – on
top of the hardboard.
2
3) Run
1
warning label and the first
5 cord covers down along
the backside of the cot
leg, between the mattress
support and the inside edge
of the cot.
4) Bring the first 4 cord covers
down the floor, and keep
the 5th cord cover vertically,
along the backside of
the cot leg, between the
mattress and the inside
edge of the cot.
5) Remove any cord slack to
make sure no parts of the
cord are loose.
6) Place the 6th cord cover
approximately 8 cm from
the edge of the mattress
support.
7) Snap together the remaining
cord covers that will run
along the floor.
1
8) Remove any cord slack to
make sure no parts of the
cord are loose.
9) Peel off the double-sided
tape on the 4th cord cover
and place it securely under
the cot leg.
10) Check to make sure the
Sensor Pad has not moved
from position and place the
mattress back inside the cot.
Hardboard
the connection pin,
2017-10-16 9:19 AM