Quick Start Guide Models: AC310, AC310-2, AC315 Power indicator Power Power Sensor pad On/Off Visual sound indicator On/Off pause Microphone Volume control +/- (on the side) Micro USB charging port (on the side) Micro USB Room Folding stand (on backside)
Page 3
(for camera) with hardware Adhesive strips (for flat micro USB cable, only for Model Touch control parent unit Wired movement sensor pad AC310, AC310-2) Camera (only for Model AC315) Flat micro USB cable (for camera adapter, only for Model AC310, AC310-2)
(more than 3 feet away). Note: Adhesive strips (only model: AC310, AC310-2) Each time you power on your camera, the internal thermometer will need to calibrate to ensure accuracy. This automatic Six strips of double-sided adhesive tape have been process will take approximately 30 minutes.
08/04/2016 Charging the Parent Unit • Prior to the first use, we recommend that you charge the parent unit Battery compartment lock for 8 hours. • Unlock the battery compartment on the backside and remove the cover. VOLUME Insert the provided rechargeable battery into the compartment. Contacts of the battery and the contacts in the compartment must be aligned.
Default Settings AC310, AC310-2: AC315: Movement Mode: OFF Movement Mode: ON Video: ON Video: ON VOX: OFF VOX: OFF VOX Level: Level 2 (of 4) VOX Level: Level 2 (of 4) Speaker Volume: Level 3 (of 4) Speaker Volume: Level 3 (of 4)
Page 7
To Activate or De-Activate the Sensor Pad Please note that during initial set-up or settings adjustment, if the movement function is activated, the movement alarm will sound after 20 seconds of no movement. Please follow the steps below to avoid this situation. 2:04 68°F 1) Press the Menu button...
Page 8
Navigating the Parent Unit In the top section of your screen you will see a blue bar with all of the necessary information concerning the status of units, alerts, temperature, and your chosen settings. Sensor pad (only for Model AC315) Camera connection Time/T emperature signal strength...
Page 9
Model AC315 Positioning the Movement Sensor Pad printed side up, under the mattress in center of the crib. 1. Position the sensor pad, 2. Insert jack 1 into the sensor pad. 3. After inserting the plug of the split cable into the port of the sensor pad, twist it clockwise to lock it. 4.
Page 10
Model AC315 Positioning the Movement Sensor Pad Note: • If the bottom of the crib is not a solid, stable surface you will need to place a hard support board (not included) underneath the sensor pad to ensure correct operation of the system. •...
Page 11
Model AC315 Adjusting the Sensitivity of the Sensor Pad 2:04 68°F • To ensure adequate monitoring of your child’s movements, you can adjust the sensitivity of the sensor pad in the main settings menu. • Set a high sensitivity for a newborn and a lower sensitivity as the child grows and gains weight.
Page 12
Model AC315 Movement Monitoring Angelcare monitors are designed to sense baby’s slightest movements and sound an alarm if no movement is detected after 20 seconds. This monitor is also equipped with “Activity Analytics” which track, record and report on baby’s bigger movements (like restlessness, rollovers and kicks).
Page 13
Model AC310-2 Viewing multiple cameras With more than one camera you can view each camera individually or use the split screen mode to view all cameras connected simultaneously. Follow the steps below for multi-camera viewing: 1) Press on your parent unit.
Designed in Canada. Made in China. While Angelcare intends to provide peace of mind to our consumers, monitoring of a premature baby or babies considered to be at risk should be carried out only under the supervision of a doctor or health care professional. This product is not intended to diagnose, treat, mitigate, cure or prevent any disease or condition. ...