Jumper Setting 1 - VIA Technologies VT8237R Manual

16
Jumper Settings
This chapter explains how to configure the motherboard's hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this
chapter whenever in doubt.
JBAT1 - CMOS Clear
JBAT1
1-2*
2-3
JP1-Keyboard/Mouse Power Select Jumper
JP1
1-2*
2-3
Note:
If you want to use PS/2 mouse or Keyboard to power on computer or
wake up from STR, you must set jumper JP1 to pin 2-3.
Technical Reference Booklet
JP1
Selection
Normal*
CMOS Clear
Select
Powered by +5V*
Powered by +5V Standby
Close Open * = Default setting.