Jumper Setting; Rtc1:Cmos Status - VIA Technologies VT82C694X Pro User Manual

Atx form factor main board
Hide thumbs Also See for VT82C694X Pro:
Table of Contents

Advertisement

2-2 Jumper Setting

2-2-1 RTC1 - CMOS Status
RTC1 is a 3-pin connector. Clear CMOS if system password is forgotten. Below
are details to show how to clear CMOS.
Procedure to clear CMOS:
Step 1: Shut down the system and disconnect the power supply from AC power.
Step 2: Pull out the ATX cable from ATX connector "POWER1".
Step 3: Short the CMOS jumper by putting jumper cap on Pin 2-3 for a few seconds.
Step 4: Return to pin 1-2 for normal setup.
Step 5: Link ATX power cable to ATX connector & connect AC power to power supply.
Step 6: Turn on system power.
If you'd like to set password, press "DEL" Key during system bootup to enter
CMOS setup and establish a new password.
VIA694X System Board

RTC1:CMOS Status

Set to "1-2"---Set to "2-3"---
Normal
9
Clear CMOS

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

694x pro

Table of Contents