Table of Contents
Advertisement
Amplifier Unit
Operating Section
Display section
Sensor Head connector
This connector is for connecting
the Sensor Head.
(*) Operating and Display Sections
HIGH indicator (orange)
This indicator lights when the
judgement result is HIGH.
PASS indicator (green)
This indicator lights when the
judgement result is PASS.
LOW indicator (orange)
This indicator lights when the
judgement result is LOW.
Main display (red)
This display shows measured
values and function names.
Sub-display (orange)
This display shows additional
information and function
settings for measurements.
ZX2 User's Manual
(*)
(*)
Connector
Laser ON indicator (green)
This indicator lights while the Sensor Head
is emitting a laser beam.
Zero reset indicator (green)
This indicator lights when the zero reset function is enabled.
ENABLE indicator (green)
This indicator lights while the Sensor is ready for measurement. It goes out
when measurement is not possible (e.g. when the received light amount is
excessive or insufficient, when the measuring range is exceeded, or when
the Sensor Head is not connected when the power is turned ON).
MENU indicator (green)
This indicator lights in the MENU mode.
It goes out in the RUN mode.
LOW threshold indicator (orange)
This indicator lights when the LOW threshold is displayed
on the sub-display.
HIGH threshold indicator (orange)
This indicator lights when the HIGH threshold is displayed
on the sub-display.
Output Cable
This cable is for connecting the power supply
and sync sensors or external devices.
(two connectors, one on each side)
This connector is for connecting Calculating Units.
Cursor buttons
These buttons are used for
switching the display and setting
measurement conditions.
MENU/SET button
This button is used for switching
the mode and confirming settings.
Smart tuning button
This is used for setting optimum sensing
conditions according to the operating conditions.
Part Names and Functions
CONTENTS
INTRODUCTION
PREPARATION
FOR
MEASUREMENT
FLOW OF
OPERATION
BASIC
SETUP
MAIN
APPLICATIONS
& SETTING
METHODS
Height
Steps
and
Warpage
Double
Sheet
Detection
Thickness
Positioning
Eccentricity
and Surface
Deflection
DETAILED
SETTINGS
TROUBLE-
SHOOTING
SPECIFI-
CATIONS
INDEX
SETTING
TRANSITION
CHARTS
19
Advertisement
Table of Contents
