Configuration
802.11a Access Point Configuration
All Harmony Access Points are configured automatically by the AP Controller or
manually using the AP Controller interface. See the User's Guide that came with your
Harmony AP Controller for information about configuring the Access Point.
Once an Access Point is added to a Harmony network, an AP Controller on that
network will automatically configure it for operation by assigning a Channel and a
value for the other networking parameters using the Access Point Defaults settings.
Once configured, the Access Point should automatically appear as an entry in the AP
Controller's Web browser interface. (If not, you may need to manually add it. See the
"Manually Adding a New Access Point" section in your AP Controller User's Guide.)
Follow these steps to configure one of the Access Point Parameters:
1.
Click the plus sign to the left of an AP Controller to view the list of its partnered
Access Points.
2.
Click the icon that corresponds to the Access Point that you want to configure.
3.
Edit one or more of the Access Point Parameters.
4.
Click SAVE.
5.
Recycle power on the Access Point if you changed any of its IP parameters.
19