Advertisement
Field Verified
Access Point Configuration
6
1. Connect to the AP via Netscape or Internet Explorer by navigating
to the URL http://<IP_Addr> (where <IP_Addr> is the IP
address of the AP). Note: these configuration steps can also be
accomplished using the Orinoco ScanTool program.
2. From the main page, click the
3. To configure WEP settings, obtain the key values from the local
network administrator and use the AP-600b, AP-2000 User Guide
for guidance in programming the encryption settings. The WEP
configuration screen is reached from the main menu by clicking
, followed by
Configure
Note that the SpectraLink 8000 Wireless Telephones must each be
configured manually with the identical WEP settings.
4. Click
, then click the
Configure
appropriate radio (
5. From the
Interfaces
is greater than 600 or disabled.
Threshold
6. Set the
Multicast Transmit Rate
7. Next go to the
Bridge
SpectraLink Voice Priority (SVP) is enabled.
8. Conditional: If the AP's software version is 2.5.xx or later, SVP
must be activated using the Avaya command line interface (CLI).
a. Connect to the access point via serial interface or Telnet.
b. Check to see if SVP is enabled by typing
then press Enter.
c.
enabled
or
disabled
d. Enable SVP by typing set
press Enter.
9. From the
tab, select
Bridge
function and disable
10. From the
Commands
The AP is now ready for use with SpectraLink 8000 Wireless
Telephones.
link.
Configure
, followed by
Security
link and choose the
Interfaces
or
) to configure.
Slot A
Slot B
tab confirm that the
RTS/CTS Medium Reservation
to
.
11Mb/s
tab, select
SpectraLink VoIP
will display.
speclinkstatus enable
Advanced Filtering
.
IP/ARP Filtering
tab, restart the AP.
Configuration Guide
.
Encryption
to ensure that
,
show spectralink
, then
. Enable the
Proxy ARP
PN: 1725-36050-001_H.doc
Advertisement
