Table of Contents
Advertisement
Installation
Installation
Determine the best location for the Harmony 802.11a Access Point using the following
considerations:
•
The length of the Ethernet cable that connects the Access Point to the network
must not exceed 100 meters.
•
Place the Access Point indoors, on a flat, sturdy surface as far from the ground as
possible, such as on top of a desk or bookcase, keeping clear of metal obstruc-
tions and away from direct sunlight.
•
Try to centrally locate the Access Point so that it will provide coverage to all of the
wireless devices in the area.
•
If using Model 8571 with external antennas:
• Place the Access Point and antennas so that the antennas can be easily con-
nected to the Access Point.
• Use the shortest antenna cable possible; use a longer Ethernet cable if neces-
sary.
1.
Place the Access Point in the desired location. If you want to mount the Access
Point to a wall or ceiling, see "Mounting Instructions" on page 14 for instructions.
Note:
2.
Connect the Ethernet port on the rear panel of the Access Point to a 10/100Base-T
network hub, switch, router, patch panel, or Harmony Power System using a
straight-through Category 5 Ethernet cable.
3.
If you are not using the Harmony Power System to supply power to the Model
8570/8571 Access Point or if you want to connect the Access Point to both the
Power System and an AC power source, use the AC power adapter included in the
product package to connect the power port on the Access Point to a working
power outlet. Use only the power adapter supplied by Proxim in the product
package. Using another power supply may damage the Access Point.
4.
The Link LED on the rear panel will light to indicate that the Access Point has a
network connection. The LED is lit green if connected to a 100Base-TX network
and lit amber if connected to a 10Base-T network.
5.
By default, the Harmony 802.11a Access Point will attempt to find an AP
Controller to partner with. If you have one or more AP Controllers on the network,
an AP Controller will automatically detect and configure the Access Point over the
network (assuming you have not disabled the Harmony System's ability to
automatically detect new Access Points). Refer to the Harmony Access Point
Controller User's Guide for more information on how to configure an Access Point.
If using Model 8571 with external antennas, install the antennas and cabling
before proceeding to Step #2.
13
Advertisement
Table of Contents
