Table of Contents
Advertisement
7
First Installation
Read sections 1-6 of this manual before you put the UFSconnect 906 into
operation.
Do not connect the unit to the mains until all installation work has been
properly carried out. In the explanation of the item "First Installation" we
assume that the receiver has been connected correctly with due regard for
the above section.
If you do not know the confi guration of your satellite reception system,
we recommend you to contact your specialist dealer for the fi rst
installation of your receiver.
7.1
Buttons required for remote control during fi rst installation
Call up the next step in the
(green)
(red)
7.2
Switch on the TV set and receiver
First switch on your TV set. Select at this the AV-/HDMI input you have used to connect the
receiver to your TV set. Switch on the receiver at the power switch on the rear of the unit.
Now perform the fi rst installation. If you have any questions or encounter problems, contact
your specialist dealer.
7.3
Step 1: Language Selection
You will see the following after
switching on the receiver for the
fi rst time:
Tip!
Always check the bar at the
bottom of the on-screen display.
These provide information on
what to do next.
14 from 64
fi rst installation
Go back one step in
the fi rst installation
Select/change
individual menu
parameters, navigation
...
Confi rm the changed
call up the submenu
Cancel entry, go back
Numeric input
values/setting;
Fig: Language Selection
Advertisement
Table of Contents
