Table of Contents
Advertisement
Before you start to use the UFS 940sw, read the sections "Safety Instructions
-
Important
Getting Started" through to the item "First Installation".
Do not connect the unit to the mains until all installation work has been properly
carried out.
The guidance given in the "First Installation" item assumes that the receiver
has been properly connected as per the "Safety Instructions - Important
Information", "Important Information" and "Connection and Getting Started"
through to the item "First Installation".
Required buttons on remote control for fi rst installation:
...
(red)
menu parameters, navigation
First switch your TV set on and select the AV channel slot you have used to connect the UFS 940sw
to your TV set. Start the UFS 940sw by pressing the on/off switch on the rear panel. The following
display appears:
Always
to the bar at the bottom
of
the
display. These provide
information on what to
do next.
Use
the
the desired menu language for your
receiver. The language selected will
be shown highlighted in yellow. The
following
languages
German, English, French, Italian, Spanish, Czech, Dutch, Polish, Norwegian, Turkish and Russian.
Press the
(green) button to move to the next menu.
Connection and Setup
Information",
Numerical input
Go back one step in the
fi rst installation
Select/change individual
Cancel input, go back
pay
attention
on-screen
buttons
to
select
are
available:
"Important
Information"
(green)
and
"Connection
Proceed to next step in
fi rst installation
Confi rm the changed
values/setting
and
21
Advertisement
Table of Contents
