Table of Contents
Advertisement
68009297001-B_Text.fm Page 6 Thursday, December 10, 2015 1:40 PM
Strap System
secures radio and/
or battery
in the
pocket.
Lock - locks the
vehicular charger within the
U-Bracket (is secured with
the use of #10 star washers
and thumbscrews.
Installation
Mounting hardware supplied includes a trunnion bracket for mounting the unit below the
vehicle dashboard, on the floor, or on the wall, and a cable for connection to the
vehicle's electrical system. The bracket enables the charger to be pivoted to a position
that offers the best security to the portable radio during rough driving conditions.
Operation Caution
•
Ensure the rear of the Vehicular Charger, especially around the heatsink is clear
of any obstruction that would otherwise restrict air movement.
•
The vehicular charger is designed for 12-volt, negative ground system.
Install the vehicular charger as follows:
1.
Plan the location for mounting the charger. Identify the routing paths for the cable and
verify that the cable length is adequate. Also check the mounting penetrations
required. On most vehicles, it is necessary to penetrate the firewall to reach the
battery. Check the opposite side of the firewall for cable clearance before drilling
holes. Protect the cable where it passes through the firewall by use of appropriate
rubber grommets (not supplied) or other protective measures.
Survey the firewall for existing holes occupied by vehicle wire harnesses. Often
there is an opportunity to route other cables using the same path. Because of the
wide variation in vehicle design, these instructions may be modified to suit each
particular installation.
6
Guide Pins - help
alignment within the
U-Bracket or trunnion
Hide quick links:
Advertisement
Table of Contents
