Specifications; Installation - Motorola NTN9176 ASTRO XTS User Manual

Tri-chemistry vehicular charger
Table of Contents

Advertisement

Specifications

Input Voltage:
Maximum Charge Rate:
NiCd:
NiMH:
Li-Ion:
Rapid Charge Cycle:
Size:
Weight:
Operating Temperature:
NiCd and NiMH:
Li-Ion:
Inline Fuses:

Installation

Mounting hardware supplied includes a trunnion bracket for mounting the unit below the vehicle
dashboard, on the floor, or on the wall, and a cable for connection to the vehicle's electrical
system. The bracket enables the charger to be pivoted to a position that offers the best security
to the portable radio during rough driving conditions.
Install the vehicular charger as follows:
1.
Plan the location for mounting the charger. Identify the routing paths for the cable and verify
that the cable length is adequate. Also check the mounting penetrations required. On most
vehicles, it is necessary to penetrate the firewall to reach the battery. Check the opposite side of
the firewall for cable clearance before drilling holes. Protect the cable where it passes through
the firewall by use of appropriate rubber grommets (not supplied) or other protective measures.
Survey the firewall for existing holes occupied by vehicle wire harnesses. Often there is an
opportunity to route other cables using the same path. Because of the wide variation in
vehicle design, these instructions may be modified to suit each particular installation.
A properly installed unit will minimize service calls and equipment downtime. Consider
the following guidelines when planning the installation:
DO consider a mounting location which will allow the unit to be mounted at a 45-degree
up angle. This angle provides operational convenience and physical security for the
portable radio under rough traveling conditions.
DO use heat shrink tubing on all splices.
11-16Vdc
13.8V Nominal
1250mA Rapid Charge, 30mA Trickle Charge
1000mA Rapid Charge, 30mA Trickle Charge
1210mA Rapid Charge, 30mA Trickle Charge
3 hours typical, depending upon battery type, capacity and
state of charge.
3.7" W x 3.7" H x 5.3" D
2 Lb (approx.)
+41°F to +122°F (+5°C to +50°C)
+41°F to +113°F (+5°C to +45°C)
AGC 2 Amp and AGC 0.25 Amp
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents