Chapter 13: Pocket Insert Installation; Removing And Replacing The Pocket Inserts In An Impres 2 Muc - Motorola PMPN4591 User Manual

Chapter 13
Pocket Insert Installation
This section provides information on how to install pocket insert into a Multi-Unit Charger (MUC).
Table 27: APX-Series IMPRES 2 MUC and Pocket Insert
Charger Model
PMPN4591_, PMPN4701_,
and PMPN4702_
NOTE: Replace an APX Pocket Insert on an APX IMPRES 2 MUC with APX Next Pocket
Insert.
13.1
Removing and Replacing the Pocket Inserts in an IMPRES 2
MUC
Required tools:
• Torque Screwdriver set for 6 in-lbs
• Torx T10 Screwdriver bit
• #2 Phillips screwdriver bit
Prerequisites:
Cleanliness
Ensure the place is clean before performing the procedure.
Ensure no debris or liquid enters into the charger.
Electrostatic Discharge (ESD) Best Practices:
Work on a hard surface such as table, counter top, or plank of wood.
Stand on a hard floor such as wood, or tile.
Wear anti-static clothing.
Use an anti-static wristband, or touch metal object throughout the procedure.
Use a humidifier in dry weather.
Procedure:
1 Unplug the power cord to the Multi-Unit Charger (MUC).
2 Remove the four screws holding the rear shroud in place by using the #2 Phillips screwdriver bit.
Charger Description
Charger Desktop Multi-Unit
IMPRES 2 6 Displays Internal
Power Supply
MN008454A01-AB
Pocket Insert Installation
Pocket Insert Kit
AS000178A01/AS000178A02
59