Battery Charge Status Indication - Motorola NNTN7624 User Manual

68009297001-B_Text.fm Page 15 Thursday, December 10, 2015 1:40 PM
LED indicators on the front panel of the charger indicate charger status:
LED INDICATOR
BLINKING RED
RED
BLINKING YELLOW
BLINKING GREEN
GREEN
ALTERNATING RED-
GREEN
ALTERNATING YELLOW-
GREEN (during first 4
seconds after insertion and
upon charge completion)
Note: Upon a recalibration recommended indication (Alternating Yellow-Green
either in the first 4-seconds after initial insertion into the Vehicular Charger or
after charge completion), please ensure within the next few charge-cycles or
days, that the IMPRES
Charger to calibrate the battery for maintaining optimal performance. Manual
reconditioning may be required when removing a battery indicating
Alternating Yellow-Green from the Vehicular Charger and inserting that battery
into an IMPRES
TM
IMPRES
the above battery is outside of the vehicular charger for more than 30 minutes
prior to inserting it into an IMPRES
reconditioning will occur.
LED INDICATOR
OFF
ORANGE
15

BATTERY CHARGE STATUS INDICATION

Battery is not chargeable or not making proper contact.
Battery is in rapid charge mode or in charge recovery due to low
voltage battery.
Battery is recognized by charger but is waiting to rapid charge. The
battery temperature is too low or high to allow rapid charging. When
this condition is corrected, the battery will automatically begin rapid
charging.
Battery has completed rapid charge (>90% available capacity).
Charger is in trickle charge mode.
Battery has completed charging and is >95% charged.
Charger is in maintenance charge mode.
(This Feature applies to IMPRES
Battery has completed charging and is fully charged. Battery
continues to be usable, but may be nearing the end of it's rated
service life.
(This Feature applies to IMPRES
Battery must be reconditioned/recalibrated in an IMPRES
Charger. Batteries not calibrated will not display fuel gauge on
TM
IMPRES radio.
TM
battery is charged in an IMPRES
TM
desktop charger within 30 minutes. This is due to an
feature that prevents battery over-charging and cycle life loss. If
REPEATER (VRS) STATUS INDICATION
Repeater (VRS) not enabled.
Repeater (VRS) enabled.
CHARGE STATUS
TM
Batteries Only)
TM
Batteries Only)
TM
desktop charger, automatic
CHARGE STATUS
TM
Desktop
TM
Desktop