Moving An Application To A Different Cfs Region - Cisco Nexus 5000 Series Configuration Manual

Using Cisco Fabric Services
Procedure
Step 1
Step 2
Step 3
The following example shows how to assign applications to a region:
switch# configure terminal
switch(config)# cfs region 1
switch(config-cfs-region)# ntp
switch(config-cfs-region)# callhome

Moving an Application to a Different CFS Region

You can move an application from one region to another region.
Procedure
Step 1
Step 2
Step 3
The following example shows how to move an application into Region 2 that was originally assigned to
Region 1:
switch# configure terminal
switch(config)# cfs region 2
switch(config-cfs-region)# ntp
Command or Action
switch# configure terminal
switch(config)# cfs region region-id
switch(config-cfs-region)#
application
Command or Action
switch# configure
switch(config)# cfs region
region-id
switch(config-cfs-region)#
application
Cisco Nexus 5000 Series NX-OS System Management Configuration Guide, Release 5.2(1)N1(1)
Purpose
Enters configuration mode.
Creates a region.
Adds application(s) to the region.
Note You can add any number of applications on the
switch to a region. If you try adding an
application to the same region more than once,
you see the, "Application already present in the
same region" error message.
Purpose
Enters configuration mode.
Enters CFS region configuration submode.
Indicates application(s) to be moved from one region into
another.
If you try moving an application to the same
Note
region more than once, you see the, "Application
already present in the same region" error
message.
Managing CFS Regions
51