Verifying The Synchronization Status Example - Cisco Nexus 5000 Series Configuration Manual

Verifying the Synchronization Status Example

Step 6
Step 7
Verifying the Synchronization Status Example
The following example shows how to verify the synchronization status between the local and the peer switch.
Procedure
Step 1
Cisco Nexus 5000 Series NX-OS System Management Configuration Guide, Release 5.2(1)N1(1)
26
Command or Action
3 policy-map type qos p1
3.1 class c1
3.1.1 set qos-group 2
3.2 class c2
3.2.1 set qos-group 3
4 system qos
4.1 service-policy type qos input p1
5 vlan 2-50
6 interface port-channel100
6.1 vpc peer-link
6.2 switchport mode trunk
7 interface port-channel10
7.1 vpc 1
7.2 switchport mode trunk
7.3 switchport trunk allowed vlan 1, 10-50
Verify the commands in the switch profile.
Example:
switch(config-sync-sp-if)# verify
Verification Successful
Apply the commands to the switch profile and to synchronize the configurations between
the local and the peer switch.
Example:
switch(config-sync-sp)# commit
Commit Successful
switch(config-sync)#
Command or Action
Enter the show switch-profile switch-profile status command.
Example:
switch(config-sync)# show switch-profile switch-profile status
Start-time: 804935 usecs after Mon Aug 23 06:41:10 2010
End-time: 956631 usecs after Mon Aug 23 06:41:20 2010
Profile-Revision: 2
Session-type: Commit
Peer-triggered: No
Profile-status: Sync Success
Local information:
----------------
Status: Commit Success
Error(s):
Configuring Switch Profiles
Purpose
Purpose